Mould is a product of the mother, the father of the process is the product, a product specific information is its mother, the decision to die; each product is fully consistent with the father, and that is technological. From this point illustrates process in production management, because technology is to ensure product consistency and integrity of unique weapon. Technology is the Know-how (expertise), is the usual ", i.e. the core competitiveness of enterprises. Many of the leading manufacturers of discovery, die and mould industry's evolving makes discerning consumers on product requirements are also increasing. Therefore, how to shorten the production cycle and more efficient, improve product quality is the manufacturers solve. Today, the manufacturers are found, by adopting the same CAD system tightly coupled process analysis tools software can save a lot of time and money.

 

The experience of quantization to process documents. Process analysis of reducing costs. Ensure that enough draft angle. Flip analysis. Control of fusion line impact strength. Perform technology ensure product quality. Technology training inheritance product requirements.

 

We have to put each specific requirements to produce a line of every employee. Because every employee to accept, if necessary, you can test to test their ability to understand and, more importantly on-site hands-on training, practical hands-on training to them, if you really can only be the formal production. Don't complain about the quality of ragged staff, we should review their training methods and frequency. Technology training to every employee, coupled with the ongoing process of supervision and quality of the audit process, we believe that our technology must be effective and controlled. If serious training or cannot execute in place, so we're going to review the process of operated method is valid and is easy to operate.